arcserve-KB : RHA | Stopped on autostop

Last Update: 2017-10-24 18:36:41 UTC
Description:  While reviewing the status of  scenario(s) in  RHA scenario manager you see one of them with the status of 'stopped on autostop'. 

Solution:  Stopped on autostop means scenario didn't stop due to an error but it stopped due to the settings configured.  An example of this is if scenario was setup to switchover automatically and after switchover the scenario is set to stop by setting the 'run reverse replication scenario after switchover' to off.  After a switchover occurs the scenario is set to stop itself so it would at that point label it as 'stopped on autostop'.  

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request